MGBBT-00296-P REV 3-1879385-6 BA XFMR EP13 SMD, ROHS MGBBT-00114 Previously MGBBT-00296 Product Description Primary Units are in inches millimetres in brackets Electrical Specifications at +20C unless noted otherwise Test Limits Unit Tol. Notes Inductance Leakage Inductance DC Resistance DC Resistance Turns Ratio Dialectric Interwinding Capacitance Total Harmonic Distortion Total Harmonic Distortion Total Harmonic Distortion Longitudinal Balance (ITU) 3.00 29.0 mH H 10% Max. 1-5 tie( 2+4 ), 10kHz, 100mVAC, Ls. 1-5 tie( 2+4, 9+7 ), 100kHz, 100mVAC,Ls. 0.660 3.30 4.5 : 1.00 1,875 75.0 -VAC pF Max. Max. 1% 500A Max. Pins 9 - 7 Pins 1 - 5 tie(2 + 4) ( 1-5 ) : ( 9-7 ) tie( 2+4 ), 10KHz, 100mVAC 1-9 tie( 2+4 ), 1 second test, 500uA maximum 1-9 tie( 1+2+4+5, 7+9 ), 100kHz, 100mVAC,Cs. -84.0 dB Max. 10kHz, 4.0Vrms [ 11.31 Vp-p ], Line : IC -76.0 dB Max. 3k (2nd Harmonic)Hz, 1.0Vrms [ 2.83 Vp-p ], Line : IC -84.0 dB Max. 3k (3rd Harmonic)Hz, 1.0Vrms [ 2.83 Vp-p ], Line : IC 55.0 dB Min. 5kHz - 400kHz. Terminal Plating is Hot-dipped SnAgCu over Ni 260C Maximum wave solder temperature per J-STD-020 Operating Temperature range -40C to +85C Meets requirements of IEC60950 for basic insulation, 250V working voltage The information contained in this drawing is the sole property of Tyco Electronics. Any reproduction or use without the written permission of Tyco Electronics is prohibited. Specifications subject to change without notice. For latest revision visit http://www.tycoelectronics.com Page 1 of 1 Date 20/01/09